Unfortunately, there is no current version of this PlasmaTalk available.
Take the opportunity to watch the recording!
Please contact our expert to request it
Sustainability and the reduction of VOC and CO2 emissions are becoming increasingly important in the energy-intensive metal industry. In particular, the production and printing of metal cans is characterized by high CO2 and VOC emissions. With the joint project between the paint manufacturer ACTEGA, the can manufacturer Brasilata and the surface treatment specialist Plasmatreat, the three partners have succeeded in developing an environmentally friendly solution to this challenge.
Join our PlasmaTalk "UV direct to metal using Openair-Plasma®" and get an insight into the patented system and the new possibilities it offers.
Gabriel Zaragüeta, Chairman of the board of Brasilata and CEO of Brasilata Labs, will start by explaining the can manufacturing process as well as the need of a protective layer in this process. Afterward, Bas Buser, Global Market Segment Manager Printing Applications at Plasmatreat, is going to give you an introduction to surface treatment with Openair-Plasma®. Learn how plasma technology creates a micro-free, clean metal surface. Finally, Antonio Galhardo, chemist at ACTEGA, presents the challenges of developing a dedicated paint suiting these special requirements and shows the advantages and disadvantages of the different painting technologies.
After attending PlasmaTalk you will know more about
- Reasons of the need for a protective coating on metal
- The advantages and disadvantages of conventional solvent-based coatings versus UV systems
- The creation of a microfine, clean metal surface that enables uncomplicated wetting and adhesion of UV coatings
- The changes in the can industry due to the use of UV curing technology in combination with plasma technology
Take the opportunity to hear first-hand from the experts about the new opportunities in the metal industry.
This free PlasmaTalk is aimed at research, development, and quality control personnel as well as design engineers, process engineers and operators of production equipment in industrial processes.
This no-charge PlasmaTalk is aimed at research, development and quality control personnel as well as designers, process engineers and operators of production equipment in industrial processes. The PlasmaTalk will last approximately 60-70 minutes plus a question-and-answer session. If you have a specific question, please send it in advance to firstname.lastname@example.org so that we can incorporate it into the program.
Please note that due to our international audience, we provide the time slot in UTC (Coordinated Universal Time).
Please check your time zone using the time calculator below (TimeCalc).