Success Story with Volkswagen
The highly efficient pre-treatment with Openair-Plasma® rendered superfluous not only the normally necessary pre-cleaning of the adherent, but also the application of solvent-containing primer coats precedent to the agglutination.
The reasons for the application of Openair-Plasma® were obvious for us. For our „Golf IV“, we developed an adhesive-bonded additional door-sealing for the avoidance of wind sounds. This self-adhesive sealing made of EPDM-caoutchouk should be fastened at the ends with additional glue dots by a MS adhesive. This caoutchouk has to be pre-treated in order to improve the adhesive’s adhesion. The conventional method is the manual application of a priming coat – a method that is no longer applied by Volkswagen nowadays.
We dicided for Plasmatreat’s in-line technology: If these sealings are pre-treated by Openair-Plasma® directly before the adhesive is applied, this method replaces several process steps. This highly efficient pre-treatment rendered superfluous not only the normally necessary pre-cleaning of the adherent, but also the application of solvent-containing primer coats precedent to the agglutination. Positive consequences for Volkswagen were: no expiry dates of the primer have to be considered, no solvent emissions and no logistic constraints with the supply.
Volkswagen counts on „sturdy processes“. They are the precondition of an equally high quality of our products. The Plasmatreat method has the big advantage of reproducibility, if the installation’s parameters are firmly monitored. As official in charge of adhesives and sealing agents in process engineering, in this regard I see Openair-Plasma® as a very safe and environmentally friendly pre-treatment method.