Technical polymer filters: secure bonding of membranes and filter end caps without leakage

The manufacture of technical filters employs almost exclusively nonwoven mono-filament/multi-filament filter material, which is made of plastic such as polypropylene, polyamide or polyester and/or polymer impregnated papers. This material is processed to make filter membranes, which must then be sealed to filter end caps. However, the hydrophobic properties of these plastics make secure bonding without leakage difficult. Leakage indicates puncture in the membrane, making it unusable.

Technical polymer filters
Secure sealing of polymer filter end caps

Openair-Plasma® offers a highly efficient solution to this problem. Both the membranes and the polymer filter end caps are pretreated through an integrated, inline plasma process before they are connected using the filter sealing compound. Plasma pretreatment effectively increases the adhesion capacity of the polymer filter material for a trouble-free, secure bonding during sealing. The result is a high-quality filter.

WEVO-CHEMIE

Reliable bonds in filter manufacturing

Bonding of filter end caps presents a special challenge in the filter industry. Very good adhesion is required here, even under extreme operating conditions, such as continuous contact with oil at temperatures around 150°C.

read success story

/Gewebe-TechnischesVlies, , , , , ,

Related press articles

Adhesion as a safety factor

YEARBOOK OF SEALING AND GASKET TECHNOLOGIES 2020
open document

Groundbreaking decision: Adhesion without primer

ALUMINIUM-PRAXIS (Kick-Off Edition11/2019)
open document

Research for civil protection: Decontamination with DBD plasma

MEDICINE & TECHNOLOGY No.1 [11].2019)
open document

Contact

We are looking forward to your inquiry

In case of questions or suggestions, we are happy to help you. We look forward to your challenge. Here you find your personal contact for your inquiry.